Home > Playsets > Playground Climbers >

Rock Grip Hand Holds
ROCK Grips - Wall Climbing Hand Holds
Wall Climbing Hand Holds


 
Rock Grip-Climbing Hand Holds
Have Questions?
888.760.2499

Click to Email Us


Price:
$32.95

Availability: Usually Ships in 1 to 2 Days
Product Code: JENS-ROCKGRIP


Color*:


Qty:
Description Installation/ Specifications
 

Rock Grip Climbing Hand Holds

Set of 12 with Hardware

Rock grips come in a set of 12. Plastic blow molded Rocks are molded from polyethylene with UV and cold weather protection. These come in 3 different shapes and are roughly 5 1/2″ x 4 x” x 2″. There are two to different sizes of mounting holes. The attaching screws and bolts are included. Now smaller sized with the bolt holes that are 3/8″ and 2″ center to center. This product should last 2 years in harsh conditions and up to 5 years in optimal conditions. Some conditions may require replacement sooner.

Due to the thermo dynamics and lower heat transfer properties of plastics they insulate better and don’t transfer the heat as quickly. Because of these properties, the Consumer Product Safety Commission (CPSC) recommends plastic slides and plastic surfaces over bare metal.

Regardless of lower heat transfer properties, plastic play equipment can still become hot enough ‐‐ in extreme temperatures and direct sunlight ‐‐ to cause burns. As is the case with all playground equipment, parents and supervisors must monitor the children in their care, make certain that the equipment is appropriate for their age, and always check playground surfaces for excessive heat before allowing children to play. For more information, contact IPEMA headquarters at www.communications@ipema.org or by calling 17172381744.

Installation: Our parts are sold as either replacement parts or components of a set, unless you are buying our Metal Frame Set, therefore these parts need to be installed according to the sets installation instructions. If the installation instructions differ from ours please contact us at 800-227-7529.

You will need twelve 1 ½” long 3/8” lag bolts and twelve 1 ½” #12 Wood Screws for each set of rocks. Determine difficulty and height wanted. For one set of rocks, use 1” plywood, for taller set, use thicker plywood. Plan configuration wanted for rocks. Place rock on board and mark with pencil where holes need to be drilled. Drill a pilot hole for 3/8” lag bolt for large hole and #12 for small hole for each rock. Then using a 9/16” socket, screw 3/8” lag bolt into rock. Do not tighten until second bolt is installed. Using a 5/16” socket, screw in the #12 wood screw. Tighten both screws. Continue procedure until all twenty-four bolts are screwed in completely. Make sure no sharp point protrudes beyond back of plywood.

Safe Use: This is for children 5 – 12 years old only. Adults should supervise children at all times. Do not allow children to use unsafely. Do not allow it to be used if damaged or wet.

Maintenance: Before and after play season and once a month during play season, check that bolts are tight. Make sure there is no cracked plastic, cracks in wood or splinters. Make sure there are not sharp edges or bolts showing through wood. Replace parts as needed. Maintain detailed inspection and maintenance records for public-use playground equipment.

Any damage from vandalism, abuse or misuse VOIDS all warranties.

Colors: Bright Blue Green Red Yellow



    Share your knowledge of this product. Be the first to write a review »